What are the wiring methods of the wall switch?

Release time:

2024-05-13

The wall switch refers to the electrical switch installed on the wall. The wall switch can be used to connect and disconnect the circuit, and the wall switch can control the switch of the lighting lamp. so we know what are the wiring methods of wall switch?

The wall switch refers to the electrical switch installed on the wall. The wall switch can be used to connect and disconnect the circuit, and the wall switch can control the switch of the lighting lamp. so we know what are the wiring methods of wall switch?

Wiring method of wall switch is as follows:

Rapid wiring: the wiring can be carried out by inserting the wire junction to be stripped into the wiring hole, without using tools such as screw clamping and power supply switch knife. There is a yellow sheet inside the wiring hole, which will be stuck when pulled out in the opposite direction. It is more convenient to insert it unilaterally. The wiring can only be pulled out after the office power socket pokes the operation wiring removal hole or pressing the operation wiring removal plate.

Double-plate wire passing: that is, according to the small screw, tighten the two small copper sheets so that the cable in the middle of the copper sheet is grasped. The actual effect of the double-plate wire passing is very good when connecting a single wire, but if two other cables with different cable diameters are connected, the cable will not be damaged, and the thin one is very easy to loosen.

Screw over the wire: that is, tighten the terminal according to the screw horizontally, and extrude the cable to make the connection with the terminal firm. The greater advantage of the screw over-wire method depends on the convenient and firm wiring, and it is not easy to spoil. The defect depends on the fact that the screw will crush or even break the cable. It is very likely that the transmission line will burn or even catch fire after a long time, resulting in risks.

The wall switch refers to the switch, which actually refers to the large area of the wall switch and the wall socket. The installation of the wall switch socket needs to meet the working conditions, the wall to be installed should be painted white, and the paint and wallpaper can only be operated after the decoration work is completed. Some circuit pipes and boxes need to be laid and insulation telemetry is to be completed.

Previous Page

Wall switch plug wire heating what are the reasons?

X7 wiredrawing series makes its debut-a work of wisdom, extraordinary enjoyment!

Next Page